POFUNG BF9500, Manual

Page: 13 / 38

BF9500
车载台使用说明书
When the channel you are operating is called, the screen shows BUSY, in this way, you can hear the calling from transmitting
party.
If the transceiver has set at higher squelch level, it may fail to hear the calling.
When the channel you are operating is called,the screen shows BUSY ,you can't hear the calling from transmitting party,it means
current channel receives a matching carrier but not match signaling(Refer to CTCSS/DCS encode and decode or Optional Signaling
setup).
5. Squelch Function
监听功能
In standby mode, short press the key open squelch, mute circuit to shut down, you will hear the background noise a
hint sound ;Again a short press close squelch, can
’
t hear background noise (two consecutive hint sound).
If you need to check whether there is the channel interference, please press this button, and then turn the volume control
knob, you can hear the background noise or interference.
6. HIGH/MID/LOW Power switch
选择输出功率
Press key until LCD display icon,then press key to switch between high/Mid/low power. The LCD appears:
·L:Transmit in low power
·M: Transmit in middle power
·None: Transmit in high power.
·Don't use high output power for a long time to call, this may result in interphone overheating and can't work normally.
·Continuous use can lead to overheating radiator, this case, be careful not to touch the radiator.
·Mobile Radio overheat protection circuit may will interphone switch to low emission power output.
7. Switch between VFO and Channel mode
工作模式切换
In standby mode, press key or Microphone [UP][DOWN]key until appear Channel number. this indicates current
channel in channel mode. Repeat above operation to switch between Frequency mode (VFO) and Channel mode.
8. Selection Frequency
选择频率
1
）
VFO Mode ( Frequency Mode )
In standby mode, press the key, switch to VFO mode, main knob clockwise control higher frequency, rotate
counterclockwise to reduce the frequency, or use the microphone key raise or lower frequencies.
2
）
MHz Mode