- 7 -
1300_GB-Attaching_2611
EN
AttAching to trActor
Preparations for initial use
Important!
1. Working positions means that the implement is lowered
and the rotor tines slightly touch the ground (A1).
010-04-17
A1
2. The distance (X) between the PTO shaft and the tool bar
must have at least 120 mm in working position (standard
measure). Observe the distance "X" particularly when
driving over ground tops!
3. The position of the rotor tines (A1) should be somewhat
parallel to the ground; less inclination to the front is
permitted.
4. Set the correct distance (X1) with the help of the threaded
spindle.
For the machines with contact wheel
(optional
equipment)"
you need to set a pivoting range of the
drawbar for a good floor adjustment of the circular tines
(A1) on uneven surfaces.
PTO shaft guarding
- Before initial use, you must check and if necessary
adjust the cardan shaft length (see also chapter "Setting
of cardan shaft" in Annex B.
Important!
Always couple the wide-angle link to
tractor - not to machine!
Beware!
P.t.o. must be
switched off be-
fore carrying out
any work in the
rotor area.
Setting the threaded spindle
Set distance (X1)
1. Couple the machine to the tractor and bring it in working
position (see above).
2. Swivel the lever (H) upwards (90°).
3. Rotate the threaded spindle accordingly.
For machines without contact wheel:
Rotate the threaded spindle to the limit
X1 = 0 mm
For machines with contact wheel:
Rotate the threaded spindle to the reach the distance
X1 = 30 - 50mm.
4. Swivel down the lever (H) (0°).
- In this position (0°) the threaded spindle is secured
against twisting.
Towing rope (option)
TIP
The towing rope is needed only with the option “hydraulic
swath apron”.
- Lay the rope (S) into the tractor cab.
