Installing or Changing the Tool to Cut the Aligner
https://www.youtube.com/watch?v=vq8tZN9lZa4
from 1:14 to 1:28
1) Make sure the spindle is off (it can be hard to tell when running at low RPM’s)
2) Locate the lever on the spindle and pull it towards you until it clicks into the “Open”
position.
3) Insert the tool into the collet with the desired amount of tool left sticking out
4) Push the lever back to the vertical (away from you), “Lock” position. Give the tool a bit of
a tug to make sure it is secure.
Turning on the Machine for the First Time
1. Plug the power cord into an outlet and then connect the other side to the machine (lower
right).
2. Plug the USB into a port on a laptop or computer, and then plug the other side into the
machine.
3. Turn the machine on (press the button above the outlet to the left, the - should be
depressed).
4. Wait 1-3 minutes for the red LED light to start blinking.
5. The first time you turn on the machine you will need to download the drivers for the
machine. Those can be downloaded here:
https://beagleboard.org/getting-started#step3
scroll down to this area and download the driver appropriate for the system you are
running. Then install the driver.
11
