PNJ DR-Wing HD, User Manual, Page: 7 / 24

-6-
1. Assurez-vous que le voltage requis pour le chargement USB correspond à la source de courant utilisée: 5V / 0.75A max
2. Si la prise de chargement ou la batterie surchauffe pendant la charge, interrompez immédiatement la charge.
3. Ne jamais laisser la batterie charger sans surveillance.
4. N’utilisez pas un autre chargeur ou câble de chargement que celui fourni avec le drone.
5. Attendez 30 minutes après le vol que la batterie refroidisse avant de la recharger.
6. Ne pas exposer la batterie à toute source de chaleur, feu ou flamme, au soleil ou à des environnements trop
chauds.
7. Ne pas court-circuiter la batterie.
8. Toujours tenir la batterie à l’écart de pièces en métal ou d’aimants.
Warning
How to Install propellers and propellers guards
The folding propellers of the drone are provided with marks A and B and are diagonally opposite.
Each helix is divided into two parts (half helix) and fits on the rotor in one direction only.
1. Clockwise rotating propellers (A on the diagram) on the front left engine and the right rear engine.
2. Anti-clockwise rotation propellers (B on the diagram) on the right front engine and the left rear engine.
3. To replace the propellers first unscrew the screws on the top of the rotor (Figure 1 and 2).
4. After removing the protective cover, pull the two damaged propellers upwards to change them.
5. Replace the two damaged propellers with two new half propellers of the same type (A or B).
6. New propellers must be fully depressed. Then replace the protective cover and tighten again.
Note:
Any maintenance or repair work on the drone must be done with the battery disconnected. Broken or damaged
propellers must be replaced by new propellers, to ensure optimal operation, always use original propellers.
Figure 1: Locate the screws
Figure 2: Unscrew
Back
Front
Cam e ra
Protective cover
B A
B A