PNI Summer P3, User Manual

Page: 9 / 12

7
Using your ice maker
Ÿ
Open the cover, remove the ice basket and pour water into tank. Keep water level
below the water level mark.
Ÿ
Press “Power” button on the control panel to begin the ice making cycle.
Ÿ
Select the size of the ice cube by pressing the “Select” button. If the room temperature
is lower than 60
℉
, it is recommended to select the small or medium ice sign button in
order to avoid ice sticking together.
Ÿ
The ice making cycle lasts approx. 6 to 13 minutes, depending on the size of the ice
cube selection and the ambient temperature. In the extreme hot room temperature,
ice-making time maybe vary a lot.
Ÿ
While the ice maker is on, verify water level periodically. If water pump can't inject
water, the ice maker will stop automatically, and the “Add Water” indicator will be on.
Ÿ
Press “Power” button, fill water up to the max. water level mark and press “Power”
button again to turn on the unit again.
Ÿ
Allow the refrigerant liquid inside the compressor at least 3 minutes to settle before
restarting.
Ÿ
The ice maker automatically stops working when the ice basket is full and the “Ice”
indicator will be on.
Ÿ
Change water in the water reservoir every 24 hours to ensure a reasonable hygiene
level.
Ÿ
If unit isn't in use, drain all water left in the tank.
EN
Troubleshooting
Problem:
The “No water” indicator
is on
The “Ice basket full“
indicator is on
Ice cubes stick together
Possible cause:
Lack of water
There is too much ice
in the machine
The ice cycle is too
long
Water temperature in
inner tank is too low
Solution:
Stop the ice maker, fill water,
and press “Power” button again
to restart the unit.
Remove ice from ice basket.
Stop the ice maker, and restart it
when the ice blocks melt. Select
the small size ice cube
selection.
Change the water in the inner
Tank. Temperature of water is
better set between 8 and 32ºC