8
9
INSTALLATION
Visor Installation
- Power Cord Operation only
1.
Attach visor bracket.
Clip the visor bracket to the back pivoting edge of your visor, so that the
plastic piece of the bracket faces downward when the visor is in its normal, stowed position.
2.
Attach the radar detector to the bracket.
Turn the radar detector upside down and mount it onto
the plastic end of the visor bracket. You will hear a “click” when the two parts are properly
connected. Make sure the screen faces you.
3.
Power-up.
Plug the small end of the straight power cord into the power jack on the side of the
radar detector. Plug the large end of the power cord into the power socket of your vehicle.
4.
Turn on the unit
by moving the power switch to ON.
5.
Reverse the radar detectorʼs text display. Press and hold
the MUTE and ALERT FILTER buttons
simultaneously for 3 seconds to reverse the text display (so messages will be seen right-side-up).
6.
Use the retaining clips to attach any loose wire
between the visor and the power socket. Be
careful not to leave any dangling wires that will distract the driver.
