PNI Sensor Corporation
DOC#1018122 r02
PNI CommBoard User Manual
Page 16
The received signal is:
“00C8 00C8”
. In this case, the return byte is not read.
Note the default delimiter,
<SP>
, is used in the received signal.
5.2.2
More RM3100 Eval Board Code Examples
Example #1:
$0wn04,00,64,00,64,00,64$1
This sentence sets all three cycle count registers to 100
D
(0x64).
Example #2:
$0wn00,70$1
This sentence requests a single measurement be taken on all 3 axes.
Example #3:
$0wn01,71$1
This sentence places the RM3100 Eval Board in Continuous Measurement Mode.
Example #4:
$0wnA4rmmm$1
This sentence first writes the address of the MSB of the MX Read register, then reads
from this byte and the subsequent 8 bytes, to provide the most recent measurement
results on all 3 axes.
5.2.3
RM3000-f Eval Board Code Examples
Example #1:
$0wn83,00,64,00,64,00,64$1
This sentence sets all three cycle count registers to 100
D
(0x64).
Example #2:
$0wn82 01$1
This sentence requests a single measurement be taken on all 3 axes.
Example #3:
$0rc9nmmm$1
This sentence first writes the address of the MSB of the MX Read register, then reads
from this byte and the subsequent 8 bytes, to provide the most recent measurement
results on all 3 axes.
5.2.4
V2Xe Code Examples
Example #1:
$0.wnaa,01,00$1.$0rnnnnnnnnnnn$1
This sentence can be used to obtain the ID packet from a V2Xe. Note the “.”
commands causes a 2 ms pause in transmission. These pauses are often necessary
when working with the V2Xe.
Summary of Contents for CommBoard
Page 1: ...User Manual PNI CommBoard...
