TRIGGER AND SHOOTING
Trigger will not pull back
Check that mechanical safety is not engaged; safety should
be fully pushed toward left side of marker and red o-ring on
safety should be fully visible
Trigger pulls back, marker will not shoot
Check that marker is cocked, air source is correctly attached,
and air source is adequately filled
Trigger action does not feel smooth
Check pin at top of trigger near trigger frame; if it catches on
the edge of the frame, use center punch to tap pin back
into place
Marker runs on (partially cycles more than
Check that air source is correctly attached and air source is
once when trigger is squeezed)
adequately filled. Check sear for wear. Check hammer o-ring
for wear and replace hammer o-ring if needed, using factory
o-ring only. Use of other than factory o-ring can cause run on.
.
VELOCITY
Low
Adjust using velocity adjuster
Low
Check that air source is adequately filled
Remove
Low
Remove bolt/hammer assembly and clean it; clean inside
receiver area where bolt/hammer assembly is located
Low
Change to a stiffer hammer spring
High
Adjust using velocity adjuster
High
Change to a less stiff hammer spring
CHRONOGRAPH THE MARKER AT REGULAR INTERVALS DURING THE DAY, AS WELL AS ANY TIME THE POWER
SOURCE IS REFILLED OR CHANGED, ANY TIME THE BARREL OR ANY PART IN THE POWER SYSTEM IS CHANGED,
AND UPON REQUEST OF ANY PLAYER OR GAME OFFICIAL.
DO NOT EXCEED 300 FPS VELOCITY.
PMI Piranha
™
21
