FIRST SWITHING ON OF THE SMART BOATHOOK MHOOK-E
MHOOK-e contains the coded call system that allows CLIK to surface: MHOOK-e
turns on when the magnetic clip is fully opened: initially it emits acoustic signals
indicating the battery charge level, followed by an Intermittent BEEP, lasting 40
seconds, to indicate the transmission of the recall code.
Close the magnetic hook
to switch MHOOK-e off.
With battery <5%, the recall code is no longer
transmitted.
The signal is sent via the emitter placed on the tip of MHOOK-e: in this phase,
the
tip must always remain in contact with the water
to allow transmission of the
code to the buoy.
Close the magnetic clip at the end of use to switch MHOOK-e
off.
Flush the device with fresh water.
CALL SYSTEM CHECK
Use the following procedure to test the buoy call system by means of MHOOK-e:
Switch CLIK on, by performing the following procedure:
(1) turn the buoy upside down for at least 2 ";
(2) bring the buoy back upright
In this position the device will be activated within 2 "and
will emit acoustic and luminous signals (corresponding to
the battery charge level); A subsequent continuous WHITE
flash will highlight the ignition.
Switch MHOOK-e on, opening the magnetic clip, and
after the battery test, during the intermittent beep, place
the tip of MHOOK-e on the sensitive area.
CLIK will respond with a series of BEEPs every time the
coded call issued by MHOOK-e is received,and the tape
release system will be reset.
Warning
: placing MHOOK-e exactly in the sensitive area
is essential for the success of the test.
REPLACING MHOOK-e BATTERIES
MHOOK-e is designed to have a battery life of a few years before changing them, however when the battery level
is <25%, it is advisable to replace them.
WARNING: ALWAYS REPLACE THE BATTERIES WHEN LEVEL IS <5% (LONG BEEP) IN ORDER TO AVOID
POSSIBLE LOSS OF ACID WITH CONSEQUENTIAL DAMAGE TO THE INTERNAL CIRCUITS. BATTERIES TO BE
REPLACED ONLY BY EXPERT PERSONNEL, OR AUTHORIZED SERVICE CENTER, CONSULT YOUR DEALER.
Procedure for replacing batteries. In sequence perform the following steps:
(1) Unscrew the 2 screws: Use a screwdriver with Torx T15
insert
(2) Remove the rod: Pay attention to the electronic circuit. If it
is present, remove the heat-shrink tube protecting the circuit.
(3)Replace the batteries: use high quality alkaline batteries.
Insert a new heat shrinker if it was present.
Proceed with reassembling the rod, taking care to insert the
control circuit inside it.
To facilitate the sliding of the bar, it is advisable to grease the
rubber gasket with silicone grease. Make the screw holes
coincide, and retighten. Tightening torque 1N.
CAUTION: DESPITE MHOOK-e IS COMPLETELY WATERPROOF IMMERSE ONLY ITS TIP TO ALLOW THE
SENDING OF CALL SIGNAL. DO NOT EXERCISE AN EXCESSIVE FORCE ON THE ARPION THAT COULD CAUSE
THE INPUT OF WATER INSIDE THE DEVICE WITH CONSEQUENT DAMAGE.
4
BATTERY LEVEL
100% - 75%
4 BEEP
75% - 50%
3 BEEP
50% - 25%
2 BEEP
25% - 5%
1 BEEP
< 5%
LONG BEEP
SENSITIVE
AREA
ELECTRONIC CIRCUIT
RUBBER GASKET
SENSITIVE
AREA
CE ADHESIVE
CE ADHESIVE
SIDE
EMITTER
Summary of Contents for CLIK EASY
Page 1: ......
