Xtreme
MAINTENANCE
202745
REV 1.0: January 4, 2021
14
7. Use the
Wrench
provided (Pg. 40) or a
½” wrench to remove the
Screen Screw
.
8. To clean or replace the
Screens
, remove the larger
O-Ring
and
Back Up Ring
.
9. Remove the
Side Seal
and
Spring
from the
Screen Screw
. Inspect all components and O-
rings. Clean or replace as required.
10. Inspect for damage and apply PMC lubrication to all O-rings and threads and reassemble in
reverse order.
11. The gun is now ready for service.
NOTE!
When replacing O-rings, replace ALL O-rings included in the
appropriate Kit.
AIR CYLINDER MAINTENANCE
1.
CLOSE
the
Manual Valves
by turning them to the full clockwise
position.
CAUTION!
Excessive force opening or closing
Manual Valves may result in damage to the
Manual Valves and/or Coupling Block.
2. Point the gun over a waste container and pull the
Trigger
to
relieve pressure.
3.
DISCONNECT
air supply to gun
.
4. Set the
Gun Lock
to the
LOCKED
position.
5. Flush the gun block to remove any residue. Use the
recommended Flush Tank (Pg. 32)
6. Loosen the
Screen Screws
using the
Wrench
provided (Pg.
40) or
a ½” wrench.
7. Disconnect
Coupling Block
from
Gun Block
using the
Nut
Driver
provided (Pg. 40).
