Xtreme
MAINTENANCE
202745
REV 1.0: January 4, 2021
12
8. Using the Nut Driver (Pg. 40) provided, remove the
gun block mounting screws (Pg 6).
9. Disconnect the Gun Block from the Cylinder.
10. Remove the Mixing Chamber and PCT from the Gun
Block.
11. Clean or replace the
Mixing Chamber
as required.
12. When reassembling in reverse order, it is
recommended to screw the
PCT
onto the
Mixing
Chamber
first, then insert the
Mixing Chamber
into the front of the
Gun Block
. This helps to
reduce wear on the
PCT
O-ring.
NOTE!
A small amount of PMC grease applied
to the Mixing Chamber and Side Seals upon
assembly is recommended.
CAUTION!
Use wooden or plastic tools or a brass brush for cleaning.
Do not use metal or abrasive tools that can scratch or damage the
contact surfaces.
