Plymovent MDB GO, Installation And User Manual

Page: 11 / 21

0000100513/050719/C MDB GO | MDB PRO 10
• (4) Put the filter module within 60 seconds on the frame.
• (5) Put a locknut on the positioning studs and
tighten them.
Fig. 4.19
<60 s
1
2
4
4x
4x
3
5
<60 s
1
2
4
4x
4x
3
5
<60 s
1
4
4x
3
5
2
4x
9x
2x
Filter module on second frame
Fig. 4.20
Multiple stack MDB system only:
• Put studs in the 9 (filter module) + 2 (frame) cage nuts
and tighten them with a flange nut.
Fig. 4.20
<60 s
1
2
4
4x
4x
3
5
<60 s
1
2
4
4x
4x
3
5
<60 s
1
4
4x
3
5
2
4x
9x
2x
Position of studs
Fig. 4.21
• (1) Remove the backing material of the seals.
• (2) Put 4 positioning studs in the upper cage nuts of the
first filter module (corner positions).
• (3) Spray SealApplicator lubricant on the seals.
• (4) Put another filter module (A)
within 60 seconds on
the previous one.
• (5) Put a locknut (B) on the positioning studs
and tighten them.
Fig. 4.21
<60 s
1
2
4
4x
4x
3
5
<60 s
1
2
4
4x
4x
3
5
<60 s
1
4
4x
3
5
2
4x
9x
2x
Filter module on first filter module
Single stack MDB system only:
• If applicable: repeat the instructions of Fig. 4.21.
Fig. 4.22
• Puts stud in the remaining 5 cage nuts between the filter
modules and tighten them with a flange nut (B).
Fig. 4.22
A
A
A
A
B
B
B
B
B
A (4x) B (5x)
Position of studs
Fig. 4.23
Multiple stack MDB system only:
• (1) Remove the backing material of the seals (hori
vertical side of filter modules).
• (2) Put 4 positioning studs in the upper cage nuts of the
filter module (corner positions).
• (3) Spray SealApplicator lubricant on the seals (horizontal
+ vertical side of filter modules)
10
.
• (4) Put the filter module within 60 seconds on the
previous one.
• (5) Put a locknut on the positioning studs and
tighten them.
Vertical connection
• Put studs in the remaining 5 cage nuts and tighten them
with a flange nut.
Horizontal connection
• Put studs in the 9 cage nuts and tighten them with a flange
nut.
Fig. 4.23
9x
4x 5x
+
<60 s
1
4
4x
3
5
2
4x
Filter module on second filter module
• If applicable, repeat the instructions of Fig. 4.21 and Fig.
4.22 to extend the MDB system (max. 4 filter modules on
top of each other).
4.5 Air inlet
(MDB-INLET)
and outlet modules
(MDB-OUTLET)
Refer to Fig. V on page 18 for possible inlet (A)
and outlet (B) positions.
4.5.1 Deflector plates
To optimize the airflow and to protect the filter cartridges, you
must install two deflector plates behind each air inlet module.