Plymovent KUA-160/2H, Installation And User Manual

Page: 6 / 16

0000101887/010920/B KUA-160 5
There are different ways to install the KUA arm.
Fig. III on page 11 gives a summary of the
relevant paragraphs per arm type (specifically H,
ATEX and S) and the preferred mounting sequence.
For mounting of the KUA-160/ H (hanging; including ATEX):
• proceed with paragraph 4.4
For mounting of the KUA-160/ S (standing):
• proceed with paragraph 4.5
4.4 Mounting of the KUA-160/H (including ATEX)
For mounting examples, refer to Fig. IV on page
11.
For mounting on the wall or on a mounting structure :
• proceed with paragraph 4.4.1
For mounting on a stanchion (PA):
• proceed with paragraph 4.4.2
For mounting on an extension crane (FlexMax):
• refer to the instruction sheet that is supplied with the
FlexMax
• subsequently: proceed with paragraph 4.4.3
4.4.1 Wall mounting
WARNING!
Before you install the product, make sure that the
wall or mounting structure is strong enough. Refer
to section 1.5 for the weight of the product.
Refer to Fig. VII on page 12 for the dimensions
and mounting measurements of the wall bracket.
The package contains no mounting hardware for the wall
bracket, since the required mounting hardware depends on the
wall type. You can mount the wall bracket on e.g.:
A a thin brick or concrete wall (min. thickness 100 mm), with
four threaded rods M10;
B a thick brick or concrete wall, with four cotter bolts
M10x120x60;
C a steel profile (e.g. H-profile), with four threaded rods
M10. For this purpose two square tubes (30x30x3 mm)
need to be mounted to prevent bending.
Fig. 4.1
• Install the wall bracket to the wall or mounting structure.
Fig. 4.1
A C
B
Mounting of the wall bracket
For mounting of the arm to the wall bracket:
• proceed with paragraph
4.4.3
4.4.2 Mounting on a stanchion
The stanchions PA-110/160 and PA-220/160 are suitable for
several mounting positions:
Mounting to/on Position
Floor
vertical
Ceiling
Wall
horizontal
Recommended mounting hardware:
Mounting of: Hardware:
Stanchion on concrete floor Anchor bolts
Stanchion to the ceiling Anchor bolts
Stanchion to the wall Depends on the wall type (also
refer to paragraph 4.4.1)
Wall bracket to the
stanchion
4x bolt M12x30 with
4x locknut M12
Fig. 4.2
• Determine the position of the stanchion.
• Install the mounting plate accordingly.
• Install the wall bracket to the stanchion.
Refer to Fig. VI on page 12 for detailed mounting
instructions of:
- the mounting plate to the stanchion
- the wall bracket to the mounting plate
• Install the stanchion to the floor, wall or ceiling.