Plymovent DUALGO, Installation And User Manual

Page: 4 / 20

0000111691/011121/B MonoGo 3
Electrical data
Power consumption 1,1 kW
Available connection
voltages
- 115V/1ph/50Hz
- 230V/1ph/50Hz
Switch box 24V
Motor design IEC
Energy efficiency n.a.
Mains cord not included
Plug not included
Welding fume class
W3 according to ISO 15012-1:2013
1.4.1 Dimensions
Refer to Fig. I on page 10.
1.5 Working range
Refer to Fig. II on page 10.
1.6 Ambient and process conditions
Process temperature:
- min.
- nom.
- max.
5°C
20°C
70°C
Max. relative humidity 90%
Suitable for outdoor use no
Refer to the available product data sheets for
detailed product specifications.
1.7 Transport of the unit
You cannot hold the manufacturer liable for any transportation
damage after delivery of the product.
- Handle the filter unit and the accompanying extraction arm
with care.
- Completely dismount the extraction arm before transport.
Dismount the arm by executing the mounting procedure in
reverse order. Subsequently the filter unit and the arm can
be transported on a pallet in the original packing.
- To prevent damage, make sure that the filter unit and the
arm cannot shift on the pallet.
2 PRODUCT DESCRIPTION
2.1 Components
The product consists of the following main components and
elements:
Fig. 2.1
A Fan + motor
B HEPA filter cassette
C Pre filter cassette
D Extraction arm (shown: hose tube arm)
E Switch box
F Shut-off damper
Fig. 2.1
A
B
C
D
E
F
Main components and elements
2.2 Operation
The MonoGo works in accordance with the
recirculation principle. Welding fume is extracted
through the hood of the connected extraction arm
by the built-in fan. The polluted air passes the pre filter
cassette and is cleaned by the HEPA filter cassette.
The cleaned air is returned in the workshop through the outlet
grid on top of the unit.
2.2.1 Indication of filter replacement
The MonoGo has a service indicator that monitors the airflow.
It gives an acoustic signal to replace the filter(s).
3 SAFETY INSTRUCTIONS
General
The manufacturer does not accept any liability for
damage to the product or personal injury caused by
ignoring of the safety instructions in this manual, or
by negligence during installation, use, maintenance, and repair
of the product mentioned on the cover of this document and
any corresponding accessories.
Specific working conditions or used accessories may require
additional safety instructions. Immediately contact your
supplier if you detect a potential danger when using the
product.
The user of the product is always fully responsible for
observing the local safety instructions and regulations.
Observe all applicable safety instructions and
regulations.
User manual
- Everyone working on or with the product, must be familiar
with the contents of this manual and must strictly observe
the instructions therein. The management should instruct the
personnel in accordance with the manual and observe all
instructions and directions given.
- Do not change the order of the steps to perform.
- Keep the manual with the product.