CAUTION!
Be careful with your operation
s.With a dangerous voltage you can suffer a dangerous electric
shock whentouching wires
3.Operate on instruction
9.Specification
2.Safety instructions
This device has left the factory in perfect condition. In order to maintain this
condition to ensure a safe operation, it is absolutely necessary for the user
to follow the safety instructions and warning notes written in this user manual.
If the device has been exposed to temperature change due to enviromental
changes,do not switch it on immediately. The arising condensation could
damage the device.Leave the device switched off until has reached room
temperature.
-The moving head is for beam spot wash effect for onsite decoration purpose.
-Don't turn on the fixture if it’s been through severe temperature difference
like after transportation,because it might damage the light due to the environment
changes.
-So make sure to operate the fixture until it is normal temperature.
-This light should be keep away from strong shaking during any transportation or
movement.
-Don't pull up the light by only the head, or it might cause damages to the
mechanical parts.
-Don’t expose the fixture in overheat, moisture or environment with too much
dust when installing it.
-And don’t lay any power cables on floor. Or it might cause electrionic shock to the
people.
-Make sure the installation place is in good safety condition before installing
the fixture.
-Make sure to put the safety chain and check whether the screws are screwed
properly when installing the fixture.
-Make sure the lens are in good condition. It’s recommended to replace the
units if there are any damages or severe scratch.
-Make sure the fixture is operated by qualified person who knows the fixture
before using.
-Keep the original packages if any second shipment is needed.
-Don't try to change the fixtures without any instruction by the manufacturer
or the appointe drepairing agencies.
-It is no in warranty range if there are malfunctions from not following the
user manual to operate or any illegal operation, like shock short circuit,
electronic shock, lamp broke, etc.
OPTICS
•Light Source :580W White LED Module
•Lumen: 20,500
•Lifetime: 50000 Hours
•Color temperature:7000K
•-CRI: at least 70, CT 7000K
•-CRI: at least 90, CT 5700K
MOVEMENT
•Pan movement:540°(16 bit)
•Tilt movement :270°(16 bit)
•Automatic reset function
COLORS
•Linear CMY+CTO
•Colors wheel:1+6colors
GOBOS
•Gobos wheel:1pcs rotation Gobo wheel +1pcs fixed Gobo wheel
•Animation wheel
27
Frame 1B
0~255
28
Frame 2A
0~255
29
Frame 2B
0~255
30
Frame 3A
0~255
31
Frame 3B
0~255
32
Frame 4A
0~255
33
Frame 4B
0~255
34
Frame angle
0~7
No effect
8~239
Angle
240~255
Rotate left and right
35
Frame angle fine
0~255
36
Frame macro
0~3
No effect
4~255
Total 63 effects
37
Scan speed
0~255
Fast to slow
38
Reset
20~29
Reset all
3
www.piu39av.com
