11
DMX512 control console control mode
In the 'User setting' interface, press the
ENTER
button to confirm. The
'Channel' mode is displayed. Use the
UP / DOWN
keys to select '
6CH
' or
'
10CH
'. Press the
ENTER
button to automatically jump to 'DMX512'
Address code setting), use the
UP / DOWN
buttons to adjust the address
code you want to set between 1 and 512. At this point you can receive
DMX512 console control signal.
If you want to use this function, please refer to the explanation below to set
DMX512 address of 4 fixtures
6CH mode: 1.: A001, 2: A007, 3: A013 4: A019
10CH mode: 1.: A001, 2: A0011, 3: A021 4: A031
Master-slave built-in program control
When connecting multiple fixtures with the commander mode, press the
ENTER
button to confirm
'OK!'
, Except for the first fixture, and the other
fixtures in the back select '
Slave
' (slave mode). When you receive the host
signal, the interface will appear '
connection
' prompt, if you disconnect the
DMX512 signal, the interface will appear '
Disconnect'
prompt, if press
ENTER
or
MENU
button, the display will exit to the previous mode. The
first fixture is used as the master, and all the show modes can be selected.
The slave will be synchronized by the master to perform the same action.
WIFI operating mode
In the 'User setting' interface, press the
ENTER
button to select '
WIFI'
(WiFi mode) and press the
ENTER
button. To connect control, open the
phone settings function, find the wireless and network
WLAN
items,
connected to the name of LED-XXX device. As shown in the picture
