Step F
Fix the wall channel with screw cover cup
S1PS08
and screw
S1SW02
to wall.
Step G
Install the top and bottom roller
S1HW02/S1HW03
to the top and bottom holes
of the moving panel. See G.1 and G.3. Slot rollers into the top profile and then clip
in the bottom rollers as shown in G.4, G.5 and G.6.
Step H
Drill 3 equally spaced holes with 3mm drill bit through the wall profile and frame.
Fix the frame to the wall profile with screw cover cup
S1PS08
and screw
S1SW03
.
Then put the screw cover cap
S1PS07
on.
Step I
Attach the magnetic strip
308GB-6
to the front of the moving panels. Adjust the
magnetic strip to ensure there is no gaps when the door is closed.
Attach the Fixed panel vertical seal
304B-1
to the fixed panel.
Attach the Moving panel vertical seal
304-2
to the end of moving panel.
Step J
Assemble the handle
S1WH01
onto moving panel.
Note:
To ensure the correct rolling action and the door closes on the profile evenly,
adjust the roller by adjusting the screw clockwise or anticlockwise as shown in G.2
G.1
A
Step A
Position the wall channel with the glass panel, support
arm
S1HW04-A
and the wall fixing A
S1HW04-B
back on
the floor ensure the wall channel is plumb, and the
support arm is level.
Step B
Mark the position of the holes in the wall. Do this by
marking the wall with a pencil through the pre-drilled
holes in the wall profile, and the position of the wall
fixing A
S1HW04-B
. Left the wall channel and glass
panel, drill with 6mm masonry drill bit and insert wall
plug
S1PS12
. Fix the wall channel with screw cover cup
S1PS08 and screw S1SW02 to wall. And also fix the wall
fixing A
S1HW04-B
to the wall.
Push the bottom seal
H-8
on the bottom of the glass
panel then insert the glass panel into the wall channel.
Drill 3 equally spaced holes with 3mm drill bit through
the wall profile and glass panel. Fix the glass panel to the
wall channel with screw cover cup
S1PS08
and screw
S1SW03
. Then put the screw cover caps
S1SP07
on.
Step C
Put the support arm on the top of the glass and tighten
all the grub screws as shown.
Step A
Position the wall channel (1 x
ALU8654
)
ensuring the wall profile is plumb,
mark the position of the holes in the wall. Do this by marking the wall with
a pencil through the pre-drilled holes in the wall channel. Drill with 6mm
masonry drill bit and insert the wall plugs (4 x
SBLTL001)
. Then fix the wall
channel using the screws (4 x
SBLTL013
)
to wall.
Step B
Drill 4 equally spaced holes with
3mm
drill bit through the wall profile
and upright profile. Fix them with screw cover cups (4 x
S1PS07
) and
screws (4 x
SBLTL003
). Then put the screw cover caps (4 x
S1PS08
) on.
13mm
B.1
A.1
A.2
A.3
A.4
B.2
B.3