EN
19 | Tom
as soon as a new change in the
schedule has been made or a new
target temperature is set.
Remove Tom from the network
It is possible to remove Tom from the
network:
Press the button for 3 seconds and
release.
Within 1 second, press again the
button for 3 seconds and release.
Within 1 second, press the button
for 10 seconds and release.
After you have released the button, the
LED will burn solid red for 5 seconds:
Tom has left the network.
Recalibrate
Calibration is performed automatically
during the start up. It can also be forced:
Press the button for 10 seconds and
release.
Within 1 second, press the button
again for 10 seconds and release,
Within 1 second, press the button
for 3 seconds and release.
The LED will blink orange slowly until
the calibration is complete.
After completion, the LED will blink
orange-green for 5 seconds if the
calibration was successful.
In case the calibration failed, the LED
will blink orange-red for 5 seconds.
Calibration will fail if Tom is not
mounted on to the radiator, as Tom
cannot determine its mounting
point.
Button sequence not recognized
When Tom does not understand the
button pattern, the LED will flash red for
0,5 seconds.
•
•
•
•
•
•
