Section 1. Getting Started
PlexWriter 48/24/48A Installation and Users Manual
5
•
Emergency eject hole: If the automatic eject button does not work, insert the
emergency eject tool, paper clip, or other thin, rigid object in this hole to eject
tray. Turn OFF power before using this feature.
Rear Panel
Figure 2: Rear Panel of the PlexWriter 48/24/48A Internal Drive
•
Digital audio output connector: Outputs digital stereo signal. For connecting to
a sound board that supports Sony/Philips digital interface (SPDIF) or Digital-In.
•
Analog audio output connector: Outputs analog stereo signal. Use to connect to
sound board or audio amplifier. Use standard MPC-3 type, 4-pin connector.
•
DMA jumper: Use the DMA jumper to convert between Ultra DMA Mode 0-2
(no jumper, default) and Multiword DMA Mode 0-2 (with jumper installed). In
general, leave this jumper at its factory setting, which is Ultra DMA (that is, no
jumper installed).
•
Mode jumper: Use the mode jumper to select operation as an IDE master or
slave, or for cable select. In general, leave this jumper at its factory setting, which
is master.
•
IDE cable connector: Connects to IDE (ATAPI) interface using 40-pin IDE flat
ribbon cable.
•
Power connector: Connects to your computer’s power supply to provide
DC +5 volts and +12 volts to the PlexWriter.
