Plessey MDR2400-SR, User Manual, Page: 116 / 131

MDR2400-SR, MDR5800-SR and Orion 5825-SR
Issue 10
Page 116
Setup for Full Duplex mode on the MDR: Max Transfer Rate
Follow the steps outlined below to setup the MDR radio in Full Duplex mode:
•
Upload the radio Firmware by following the aforementioned procedure. Full
duplex Ethernet operation is supported from version 2 of the firmware.
•
Setup default configuration of the radio to the required configuration. Refer
to Section 2.3.4 for a description of the different default configurations.
•
Ensure that the PCB revision of the IU is issue_2_mod_a(3) by reading the
following MIB element: 1.3.6.1.4.1.1316.1.1.1.2.4.15
mdrmteIndoorUnitPCBrevision. If the PCB revision is
issue_2(2) the radio
hardware does not support Full Duplex Ethernet mode.
•
Disable all tributary channels to make the maximum user bandwidth
available for Ethernet traffic.
•
Enable Full Duplex mode via the MIB using element:
1.3.6.1.4.1.1316.1.1.1.4.16 mdrmteEthernetFullDuplex.
• Set the data rate to T1 if required using MIB element:
1.3.6.1.4.1.1316.1.1.1.2.1.1 mdrmteDataRate.