owner
’
s
manual
2011
ford
excel
Page 25
trouBle shootIng:
if the pump will not prime, please check:
- to make sure there is water in the holding tank
- to make sure that the battery is not run down
- for kinks in the inlet water line
- for leaks at inlet fittings (if air is leaking into inlet fittings, tighten fittings or apply
clamps as necessary)
- for clogged lines
- the inline flow filter, located beside your water pump.
if the water pressure drops:
- make sure faucet aerators are clean
- check to make sure there is water in the holding tank
- check to make sure the battery is not run down
- check faucets and connections for leaks.
if the pump runs when there is no apparent demand for water:
- make sure there is water in the holding tank
- check all faucets and fixtures to make sure they are all shut off and not leaking
- check line for leaks.
toIlet
Please refer to the manufacturer’s operating instructions.
toilet trouble shooting:
1. Water keeps running in the bowl:
- check to see if all the levers are turned all the way back. Sticking may be
caused by foreign material on the waste valve blade seal at the bottom of the
bowl. if the problem persists, you may need to replace the water valve.
2. The Toilet leaks, there is water on the floor:
- if the leak is in the back of the toilet, check the water supply line connection
and refer to the manufacturer’s installation instructions. if the leak is at the toilet
flange area (where the toilet mounts to the floor), check the toilet flange nuts to
tighten.
3. Poor flush pressure:
-
the levers must be held fully open during the flush. a good flush should be
obtained within 2 to 3 seconds. if the problem persists, remove the water
supply line and check the water supply. The water supply rate should be at least
10 litres/2.5 gallons per minute to ensure an adequate flush.