14
ASSEMBLING LOGS
WARNING:
Failure to position the parts in accordance with these diagrams or failure to use only parts
specifically approved with this log set may result in property damage or personal injury.
CAUTION:
After installation and periodically thereafter, check to ensure that no yellow flame comes in
contact with any log. With the log set set to High, check to see if yellow flames contact any log. If so,
reposition logs according to the log installation instructions in this manual. Yellow flames contacting
logs will create soot.
It is very important to install the logs exactly
as instructed. Do not modify logs; use only logs
supplied with log set. Each log is marked with a
number, and this number will help you identify
each log during installation.
Provided Logs: 7
1. After optional acces-
sories are installed (see
page 11), slide both
risers onto the back of
the grate. Make sure
the back of the grate is
flush with the back of
the riser.
2. Place log #1
and #2 on the top
of the front grate
and make sure the
break between the
two logs is centered
on the grate and the
logs are touching.
3. Carefully place log
#3 on the top of the
risers. Make sure the
log is centered on top
of the risers.
4. Place log #5 so it is
resting on the top right
of logs #2 and #3.
5. Place log #6 so it
is resting on log #4
and somewhere on
the break of logs #1
and #2.
6. Place log #7 so that it is
resting on logs #1 and #5.
3
1
2
3
4
5
6
7
Fig. 23 - Installing Risers
3. Place log #4 so it is
resting on the top left
of logs #1 and #3.
Fig. 24 - Installing Logs
#1-#2
Fig. 25 - Installing Log #3
Fig. 26 - Installing Log #4
Fig. 27 - Installing Log #5
Fig. 28 - Installing Log #6
Fig. 29 - Installing Log #7
NOTE:
These log installation instructions are recom-
mended to decrease the amount of sooting the most.
Back of grate
VL-AA24D/VL-AA30D/VL-NO24D/VL-NO30D/VL-CA24D/VL-CA30D
1
2
3
4
5
6
7
Summary of Contents for VL-AA18D
Page 2: ......
