21
ASSEMBLING LOGS
WARNING:
Failure to position the parts in accordance with these diagrams or failure to use only parts
specifically approved with this heater may result in property damage or personal injury.
WARNING:
All previously applied loose material must be removed prior to reapplication
CAUTION:
After installation and peridically thereafter, check to ensure that no yellow flame comes in
contact with any log. With the heater set to High, check to see if yellow flames contact any log. If so,
reposition logs according to the log installation instructions in this manual. Yellow flames contacting
logs will create soot.
It is very important to install the logs exactly
as instructed. Do not modify logs; use only logs
supplied with heater. Each log is marked with a
number, and this number will help you identify
each log during installation.
Provided Logs: 8
Fig. 19 - Installing Log #1 Fig. 20 - Installing Log #2-3 Fig. 21 - Installing Log #4
1. Insert log #1 onto pins in
middle grate base.
2. Place log #2 & #3 onto
the front grate. Make sure
the recessed areas on
the log match up with the
grate, and the inside end
of each log is centered on
grate.
3. Place log #4 so it is rest-
ing in the top left recessed
areas of logs #1 & #2.
Fig. 22 - Installing Log #5 Fig. 23 - Installing Log #6 Fig. 24 - Installing Log #7-8
4. Place log #5 so it is
resting in the top right
recessed areas of logs #1
& #4, and just touching the
top right of log #2.
5. Place log #6 so it is rest-
ing in the crotch of log #4
and so the crotch of log #6
is in between log #5.
6. Log #6 & #7 are optional
- decorative logs that can
be placed anywhere NOT
on the unit, but on the floor
of the firebox. It is recom-
mended to place them as
illustrated.
1
2 3 4
5 6
7
8
1
2
3
4
5
6
7
8
Summary of Contents for VFL-CY24DR
Page 2: ......
