11
OPERATING INSTRUCTIONS
The infrared remote control relies on a line of sight and must be pointed at the controls of the
log set to work. The remote control unit has the controls required to turn ON/OFF both the main
power and the heater. If you prefer to use the control buttons on the log set unit itself, they are on
the lower right corner of the unit. The layout of the buttons and remote control unit can be seen in
Figures 2 and 3, respectively.
The plastic tab inside the battery
compartment MUST be removed
before the remote control will operate.
(Pull tab)
Battery replacement instruction
CR2025
OPEN
PUSH
RELEASE
Figure 3
1
2
3
IMPORTANT:
Under normal operation, when power is
interrupted from either an outage or from unplugging unit
from wall while still in operation, the heat level indicator
lights may blink repeatedly and the unit will cease operation.
In order to reset the unit, unplug for 10 minutes, then plug
back in and operate normally in accordance with the Use
and Care Guide.
Plug your log set into a 15-amp, 120-volt power outlet.
1. Turn the power on. Flame will show on the wall be
hind the log set.
2. Remove the plastic tab from inside the battery
compartment to activate the remote control.
3. Point the remote control directly at the control buttons
of the log set and use the buttons to operate the log set.
Main Power Button (1):
This button supplies power to all the functions of the
electric fireplace. The main power button must be in the
ON position, either from the remote or the controls on the
electric fireplace for the functions to work.
Heater Control Button (2):
This button controls the heater ON/OFF and 5 temperature
modes from Low to High. When the heater is first turned
on, the heater will come on at the lowest room temperature
setting. The log set will remember the last heat setting. In
later use, the heater will start at that setting, unless power
to the unit has been interrupted. Each time this button is
pressed, the temperature set point increases, allowing you
to adjust the ambient temperature.
Flame Control Button (3):
This button controls the brightness of the flame effect with
settings at High, Medium and Low. When the log set is first
turned on, the flame will come on at the highest setting. The
log set will remember the last flame setting used. In later
use, the flame brightness will start at that setting, unless
power to the unit has been interrupted. Each time the
Flame button is pressed, the flame brightness decreases.
The only way to turn off the flame effect completely is to
turn off the Main Power button.
Battery Replacement Procedure:
(Size CR2025)
