10
©
2006 Pacific Cycle, Inc.
Step Illustration
Instructions
Hardware
Reference
1
Remove the screws, washers, and lock nuts from
the holes in the slide.
Part Ref. #: PSHW24
2
Insert the rail/ladder legs through the holes in the
top of the slide. Align the ladder holes with the
slide holes.
3
Insert the screws through the holes in the back of
the slide and secure them to the hand rails with the
screws and locking nuts provided.
Part Ref. #: PSHW24
4
Locate the slide front legs and insert them into the
front hand rail tubes on the underside of the slide.
Align the holes and secure with the screws,
washers, and lock nuts.
Part Ref. #: PSHW24
5
Slide the two ladder steps onto the legs of the slide.
Align the holes and secure the steps with the
screws and locking nuts. The screw head should
be facing the outside.
NOTE:
Once assembled and the slide is standing
upright, the steps should be flat and parallel with
the ground. If they are at an angle, they will need
to be removed, turned around, and reassembled.
Part Ref. #: PSHW5
6
To attach the slide to the frame, locate the two link
bars, remove the hardware, and re-attach to the side
support bar with the holes.
Part Ref. # PSHW17
TIP:
In order to keep the slide legs from sinking into the ground, place a flat rock or a brick under the legs. You should dig
out a place for the brick so the slide remains even.
