For Customer Service Call
800.333.8519 (U.S.A.) or
541.955.9199 (International)
Manufactured by Krauss Craft, Inc.
www.playcraftsystems.com
GYRO-POD SPINNER
INSTALLATION INSTRUCTIONS
Rev H
1/5/2017
1974
Page 7 of 9
For Customer Service Call
800.333.8519 (U.S.A.) or
541.955.9199 (International)
Manufactured by Krauss Craft, Inc.
www.playcraftsystems.com
GYRO-POD SPINNER
INSTALLATION INSTRUCTIONS
Rev H
1/5/2017
1974
Page 7 of 9
1/4"x 1-1/4" BH TR
Tek Screw
R5 SPLIT COLLAR
HALF
Figure 1.5
TOP FRAME
Step 10
Place Gyro-Pod Leg into footing hole and attach
Gyro-Pod Bearing Hub to Top Frame as shown
in Figure 1.4. (See Notes A, B, C & D)
Step 11
Secure Top Frame and Split Collar Halves to post
as shown in Figure 1.5. (See Note C)
Step 12
Apply Gyro-Pod Warning Label where visible to
users as shown in Figure 7.
Step 13
Fully tighten all fasteners according to the
"TIGHTENING TORQUE FOR HARDWARE"
section of the Installation Manual.
Step 14
Plumb and level entire component. Pour concrete
into footing hole. Allow at least 72 hours to cure
before using this equipment. (See Notes B, C & D)
Step 15
Place required protective surfacing under and
around Gyro-Pod Spinner. (See Note E)
BALL JOINT
SOCKET HALF
3/8" x 2-1/2"
Shoulder Bolt
1/2" SAE Washer
1/2" SAE Washer
3/8" x 2" Barrel Nut
GYRO-POD
BEARING HUB
Figure 1.4
TOP FRAME
FIGURE 7
Gyro-Pod Spinner
Warning Label
(Finish Grade)
44"
1118mm
