9/ 26/ 2008 11: 01: 38 AM, Rachel
Maintenance
Periodically tighten all screws, bolts and nuts. A
periodic inspection of all parts is necessary. If a part
is broken or worn, replace immediately. For general
maintenance please refer to our Playground
Maintenance Manual.
Parts List
181205
181206
541000
9103052-TR
9103072-TR
9333002
9333042
Ramp Wheelchair Halves Black
Border Timber Connector
BorderScape
TM
Timber Stake
Bolt Button Head 3/8" x 1"
Bolt Button Head 3/8" x 1-1/2"
Washer Flat 3/8" x 1" x .100 thick
Washer Flat 3/8" x 7/8" O.D.
RAMP WHEELCHAIR HALVES BLACK:
Shall be constructed of UV-stabilized, rotationally
molded, Recycled Plastic with an average single
wall thickness of 1/4" with a molded-in footing base.
The Ramp Halves shall be approximately 41" wide
and 72" in length with a sloped surface that is 9"
thick at it's thickest side and less than 1/2" at the
end.
BORDER TIMBER CONNECTOR (RAMP):
Shall be constructed of UV-stabilized, rotationally
molded, Recycled Plastic with an average single
wall thickness of 1/4" with a molded-in footing base.
The Border Timber Connector shall be
approximately 4" thick and 10" in length and 12" tall.
BORDER TIMBER 4'L BLACK:
Shall be constructed of UV-stabilized, rotationally
molded, Recycled Plastic with an average single
wall thickness of 1/4" with a molded-in footing base.
The Border Timber shall be approximately 4" thick
and 52" in length and 12" tall.
HARDWARE:
Shall be stainless steel, zinc/nickel plated or
galvanized as required to resist rust and corrosion.
Specifications
2
2
2
8
8
8
8
Installation
Step 1.
Loosely attach Ramp Halves using Border Timber
Connector. Refer to Figure 1 for hardware type and
orientation.
Border Timber Connectors
must be
installed with the top and bottom reversed
for the opposite side of the Ramp Halves for
connection to Border Timbers. See also Assembly
View for additional details.
Step 2.
Install Border Timbers and connect to Ramp
Assembly using Borderscape
TM
Timber Stakes.
Refer to Figure 2 for hardware type and orientation.
Step 3. *Use this Step when installing Border
Timbers without a Ramp Assembly*
Attach Border Timbers together using
Borderscape
TM
Timber Stakes. Refer to Figure 3 for
hardware type and orientation.
Step 4.
For installation of Ramp Halves over hard surfaces
(i.e. concrete) refer to Figure 4. See also Hard
Surface Mount Diagram and Notes B and C.
Step 5.
Apply liquid thread lock and fully tighten all fasteners
according to the "TIGHTENING TORQUE FOR
HARDWARE" Section of the Installation Manual.
See Note A.
Manufactured by Krauss Craft, Inc.
www.playcraftsystems.com
For Customer Service Call
800.333.8519 (U.S.A.) or
541.955.9199 (International)
ACCESS RAMP, BORDER TIMBERS and CONNECTORS
1205
Rev A
Page 3 of 3
Border Timbers
540407
541000
Border Timber 4'L Black
Borderscape Timber Stake
-VARIES-
1 per
Border
Timber
