5
800.791.8056
▪
www.spectrumproducts.com
e. Fill the hole in the deck around the anchor with non-expanding concrete. Set the anchor
so that the finished top is 1/8” to 1/4” below finished deck level – allowing for anchor cap
to be put in place when the lift is not in use.
f. Use a carpenter’s level, to level the anchor making sure that the Aspen II mast will be
vertically straight - up and down (perpendicular to the deck) in all directions. It is
important that the mast be vertically straight to ensure ease of rotation when the lift is
fully loaded.
Allow the concrete/Grout/Epoxy to cure for at least 7-days (or manufacturers recommended set
time) before installing and using the lift.
Assembly Instruction
The following tools will be required to complete assembly and installation of the lift:
-
9/16” ratchet and open-end wrench
-
1/2” ratchet or open-end wrench
-
3/16” socket wrench (allen wrench)
-
7/32” socket wrench (allen wrench) *Included*
LIFT ASSEMBLY
NOTE: All steps reference the exploded view on page 3.
!CAUTION! Do not rotate the actuator end fitting – handle with care.
a.
Stand the mast assembly up in the anchor that is installed in the pool/spa deck.
b.
Carefully remove shrink wrap holding the actuator to the mast assembly
c.
Attach the actuator end fitting as shown on page 3 using:
1 - 3/8” Shoulder Bolt 1 ¼” x 5/16” - 18
1 - 3/8” Flat washers
1 - 5/16” - 18 Nylock nut
d.
Slide the battery down until it mates with the Wireless Receiver, and locks into place.
When properly installed the battery will sit flush against the top of the Wireless Receiver.
The Control Box battery indicator light should indicate a fully charged Battery (Green
Light). If the battery indicator light does not illuminate, ensure that the battery is turned
on by pressing the push button on the front of the battery case to the on (in) position. If
the battery indicator light shows amber or red, charge battery before moving to the next
step.
e.
Test lift operation by pushing the up and down toggle switch on the Wireless Receiver to
ensure the lift is operational (See page 8 for instructions on using Wireless Transmitter).
