MPS-5 User Manual
10
CHANGING BATTERIES ON REMOTE
hex socket
screws, use
3/32" hex key
to open
-
+
+
-
Back cover removed
Backside of remote
AAA Batteries
The remote operates with 2 AAA
size batteries. In order to change
them the back cover needs to be
removed as shown in picture on the
left. Make sure that replacement
batteries are inserted with their
polarities as indicated in the picture.
The screws can be opened with a
3/32” hex or Allen key.
CONNECTING THE MPS-5 TO A WINDOWS BASED PC or APPLE MAC
The MPS-5 provides 2 different ways for you to connect to a computer:
1. Via its internal USB connector on the back panel. This connection is limited to 16bits and 44.1 /
48kHz.
2. Via the USB-X interface. This connection supports PCM resolutions of up to 24/384kHz and DSD up
to 5.6448MHz.
1. CONNECTING THE MPS-5 TO A PC VIA ITS INTERNAL USB INTERFACE
Again, the MPS-5 is equipped with an internal USB port that only supports PCM in 16bits and 44.1/48kHz. In
order to guarantee the best sonic performance of the MPS-5 when playing from other sources connected to
other inputs or from its internal transport the USB port is disabled. This makes it necessary that when a PC is
booted the USB (PC) input is selected on the MPS-5 BEFORE connecting the USB cable from the PC. This
allows the operating system on the PC to identify the MPS-5 and configure its audio port. Once the
connection has been established and the PC is not turned off the input selection on the MPS-5 can be
changed freely without the need to disconnect and reconnect the USB cable. However, when the PC is power
cycled the enumeration is lost and the above described procedure is necessary to gain it back.
The following operating systems are supported without any additional driver installation: Microsoft Windows
XP or later (English and Japanese editions), Apple Mac X 10.0 or later (English and Japanese editions).
All manuals and user guides at all-guides.com
