1
2
3
4
5
Front axle
Tools required: Spanner
Remove all the parts from the front axle.
1. Slide a
Ø10 washer
onto the
front axle
.
2. Slide the
normal wheel
onto the rear axle.
3. Slide a
Ø10 washer
onto the
front axle
.
4. Tight a
Ø10 Locknut
to the end of the
front axle
with a spanner.
5. “Snap” the
hubcap
to the wheel cover.
Repeat this step for the other side.
GAP
After assembling any wheel to the axles, please check the gap
between the screw thread and the collapsible (refer to below picture), if
the gap is too big, please add two or three washers inside the wheel, But
after tightening the nut outside the wheel, please turn the wheel by your
finger to check if the wheel can run smoothly, this is very important,
because if the wheel can run smoothly, it is ok, but if the nut press the
wheel and the wheel can’t run smoothly, the motor will be broken easily!
Then you need to decrease one or two washers to make sure the wheel
can run smoothly!
Attach the Front Wheels
│
8
