Service Manual
Setup
Big Buck Hunter® Pro Open Season is a trademark of Play Mechanix™ Inc. All rights reserved.
Page 6
Setup
1.
Place the shipping crate on a flat stable surface.
2.
Cut the banding straps and remove the cardboard lid.
3.
Lift off the large cardboard container surrounding the cabinet and any shipping cleats.
4.
With at least two people and a dolly, remove the cabinet from the shipping pallet.
5.
Remove the coin door key from the coin return chute.
6.
Open the top coin door.
7.
Locate the key for the back door and the cash box.
8.
Open the cash box and remove the plastic tube.
9.
Remove the items inside the tube. These include this service manual, AC line cord, bag of tools
and a warranty card.
10.
Using a wheeled cart and at least one assistant, transport the cabinet to a suitable playing area.
11.
Remove packing material from the guns.
12.
Ensure the game cabinet is level and stable.
With at least one assistant, adjust the leg levelers.
13.
Check the AC line cord for visible signs of damage.
Pay particular attention to the plug and line cord insulation.
14.
Check for shipping damage to the following:
Gun assembly: Left and right guns, gun holders, and cable
Cabinet glass: Marquee and monitor
Cabinet back door
Cabinet coin door
Cabinet and gun decals
15.
Verify the voltage in the nearest AC outlet.
16.
Verify the AC outlet ground connection is present and working.
17.
Open the back door of the cabinet.
18.
Near the AC power transformer, verify the voltage selector switch is set for the correct AC
voltage.
19.
Remove the marquee.
20.
Verify the fluorescent fixture in the marquee is set for the correct voltage.
21.
Plug the line cord into the AC outlet.
22.
Replace the back door.
23.
Turn the power switch to ON.
24.
Verify that the cooling fan located on the bottom back of the VGM is working.
If not, turn off AC power and disconnect line cord. Refer to the diagnostic section of this manual.
25.
Check that no component is excessively hot or emitting foul odors.
If not, turn off AC power and disconnect line cord. Refer to the diagnostic section of this manual.
26.
Once software loads, you will be asked to calibrate the guns.
If not, enter the service menu by pressing the TEST button located on the bracket inside the top
coin door.
