12
d) Beat cap 80 x 40 into the upright (use a mallet if necessary), adjust lower
hinge and tighten fixing screw. Take care that the hinge at the bottom is
flush with the upright’s cap.
e) Fix net hoops in the hinges.
Take care that the end of the net hoop with 2 boreholes (round tube) is fixed
in the upper hinge and the end with 1 borehole (square tube) is fixed in the
lower hinge.
Boreholes of hoops have to be congruent with boreholes of the hinges.
f) Fixing of the hoop at the upper hinge:
Stick from the top hexagon screw DIN 933, M 8 x 60 through the first
borehole of hinge and hoop. Then add washer DIN 125, Ø 8.4 mm at the
hinge lower side, screw one self-locking cap nut DIN 986, M 8 only so tightly
that the net hoop can still be folded.
Fixing of the hoop at the lower hinge:
Stick from below slotted countersunk head screw DIN 963, M 8 x 60 through
hinge and hoop. Then add washer DIN 125, Ø 8.4 mm at the hinge upper
side, screw one self-locking cap nut DIN 986, M 8 only so tightly that the net
hoop can still be folded.
