Technical Support: (909) 259-6001
BARRIER
2
General Safety Precautions
This installation manual is intended for
professionally competent personnel only.
Installation, electrical connections and
adjustments must be performed in accordance
with Good Working Methods and in
compliance with applicable regulations.
Before installing the product, carefully read
the instructions. Bad installation could be
hazardous. The packaging materials (plastic,
polystyrene, etc.) should not be discarded
in the environment or left within reach of
children, are these are potential source of
hazard.
Before installing the product, make sure it is in
perfect condition.
Do not install the product in an explosive
environment and atmosphere : gas or
inflammable fumes are serious hazard risk.
Before installing the motors, make all structural
changes relating to safety clearances and
protection or segregation of all areas where
the risk of being crushed, cut or dragged, and
danger areas in general. Make sure the existing
structure is up to standard in terms of strength
and stability. The motor manufacturer is not
responsible for failure of use Good Working
Methods id buildings frames to be motorized
or for any deformation occurring during use.
The safety devices (photocells, safety edges,
emergency stops, etc.) must be installed taking
into account: applicable laws and directives,
Good Working Methods, installation premises,
system operating logic and the forces
developed by the motorized barrier.
The safety devices must protect any areas
where the risk exists of being crushed, cut or
gragged, or where there are any other risks
generated by the motorized barrier.
Apply hazard area notices required by
applicable regulations.
Each installation must clearly show the
identification details of the motorized barrier.
Before making power connections, make sure
the plate details correspond to those of the
power mains. Fit an omnipolar disconnection
switch with a contact opening gap of at least
3mm.
Make sure adequate residual current circuit
breaker and overcurrent cutout are fitted
upstream of the electrical system. When
necessary, connect the motorized barrier to a
reliable earth system made in accordance with
applicable safety regulations.
During installation, maintenance and repair,
interrupt the power supply before opening the
lid to access the electrical parts.
The handle electronic parts, wear earthed
antistatic conductive bracelets. The motor
manufacturer declines all responsibility in the
event of component parts being fitted that
are not compatible with the safe and correct
operation.
For repairs or replacements of products only
original spare parts must be used. The installer
shall provide all information relating the
automatic, manual and emergency operation
of the motorized barrier, and provide the user
with operating instructions.