11
- Secure with the 4 N°7 (3.9 x 9.5) TF screws
- Insert an aluminium coupling sleeve, put some silicone filler into the hole and position a TF MS x 8 screw (do not tighten or
it will be difficult to put the second screw in place).
- Put a second spar into position, put some silicone filler in the hole and position the screw (once the two screws are in position
they may both be tightened). Wipe off any excess filler with a cloth.
- Insert PVC liners as you go along (ensure they are flush against the prefeeder)
- Repeat the process until only one spar is left
Cutting the last spar
- Position the last spar so that it lies flush against the previous spar but do not install it
- Measure a distance of 5 cm back from the sleeve of the forestay
- Mark and cut the spar with a hacksaw
- Put a coupling sleeve into position
- Insert the spar, then insert and tighten the screw
5 cm
- Position the last PVC liner
- Mark the liner level with the end of the aluminium spar
- Cut and insert the PVC liner
mark
end of last PVC liner
