11
Dingo Pup User Guide
Programs
0:
Liquid Electrolyte Battery with Low Battery Disconnect option
(p.12)
1:
Sealed batteries (AGM or Gel) with Low Battery Disconnect option
2:
Liquid Electrolyte Battery with Light Controller option
(see p.12)
3:
Sealed batteries (AGM or Gel) with Light Controller option.
4:
Customised setup. Choosing this program will require you to set a
number of additional parameters.
(see Reference Manual)
3. Set the System Voltage
Short-push to move from “TIME” to “VOLT”.
a. Long-push and the voltage will start flashing.
b. Short-push until the voltage is correct for your battery. If
you pass 48V, it will cycle back to 12V.
c. When the voltage shown is correct, long-push to set it.
4. Set the System Program
Short-push to move from “VOLT” to “PROG”.
The program number determines battery regulation settings if the Pup
becomes separated from the Dingo System. See page 22 for details.
a. Long-push and the program number will start flashing.
b. Short-push to select the best program for your batteries:
c. When the program shown is correct, long-push to set it.
4. Set any advanced (program 4) settings
Information about the “REG”, “MODE” and “EVNT” settings
is in the Pup reference manual. Contact Plasmatronics
support or download the reference manual from the
Plasmatronics web site..