Plas-Ties TIE-MATIC 603, Operating Manual, Page: 14 / 22

SECTION VI: Troubleshooting
F. Tie length
short a. Oil or grease on mate-
rial feed drum
b. Improper adjustment of
idler lever stop
c. Brake arm binding
d. Material snag in spool
a. Clean with appropriate
solvent
b. Adjust stop (See Ad-
justments V)
c. Check material align-
ment on spool
d. Take out snag and re-
thread
Condition Cause Correction
Page 15
G. Machine
won’t stop at
end of cycle a. Replace switch
b. Replace spring
c. Replace motor a. Defective limit switch
b. Switch activating cam
spring defective
c. Defective motor
H. Machine not
working a. Align the orange dot on
the cam with the or-
ange dot on the pinion
to start the machine at
“HOME” position.
b. Clean jammed material
a. Switch Actuating cam is
not at HOME position
b. Material jammed at
pinion support