CAUTION:
DO NOT OVER-OIL OR OVER-LUBRICATE MACHINE
It is important that the material feed drum and idler pressure wheel be kept free
of lubricants. Excess lubrication to the drum (Item #425 of Appendix B) will re-
sult in an improper tie due to material slippage, requiring a thorough cleaning of
the material feed drum and idler wheel before reuse. Excess oil lubrication could
damage the motor.
Page 13
SECTION V: Adjustments
M
ATERIAL
F
EED
I
DLER
(A
PPENDIX
B, I
TEM
#195)
In the event that the length dimension is out of specification and adjustment is
required, perform the following:
1. Cycle the machine to measure the tie length (see page 10, Ribbon Length
Per Model)
2. If out of specification, loosen adjusting screw nut (Part # P001070) - Marked
with Green or
▲
on Figure IV-2)
3. To increase the length of the tie, turn the set screw (Part # P001230) counter-
clockwise. Turning clockwise will shorten the tie length. Adjust as neces-
sary.
4. To keep the settings, secure the screw nut.
(Figure IV-2)
SECTION IV: Maintenance
▲
Summary of Contents for TIE-MATIC 603
Page 20: ...Page 21 Appendix A Case Cover...