The RX-35F supports Hot Plug and it may be removed while the PC and the
adapter itself are up and running. To ensure safe operation, however, it is
recommended to perform the following steps to remove the RX-35F.
1. Locate the Task Tray in the lower-right corner of the desktop screen, and
open "Removing or Disconnecting Hardware".
2. The following window will be displayed (see the image below). From
the list of devices, click on "LSILogic SYM13FW500-Disk DRIVE
IEEE1394 SBP2 Device" and then click on the Stop button.
17
RX-35F
16
RX-35F
1. Open Control Panel in My Computer, and then open System as well.
2. Select the Hardware tab, and then click on the Device Manager tab.
3. Verify that an icon labeled "LSILogic SYM13FW500-Disk DRIVE
IEEE1394 SBP2 Device" is visible under Disk Drive.
If this icon is not visible under "Disk Drive" OR a "?" or "!"symbol appears
for the item, it means that the driver has not been installed properly. Either
remove and reattach the IEEE1394 cable to let the PC recognize the RX-
35F again, or click on (highlight) "LSILogic SYM13FW500-Disk DRIVE
IEEE1394 SBP2 Device" and right-click the same device to select
"Uninstall". Then re-install the adapter following the steps described in
Section 4-1.
4
2
Verifying the Installation
4
3
Removing the RX-35F
Summary of Contents for PCi RX-35F
Page 2: ...RX 35F ...
Page 23: ...34 RX 35F ...
