Planex Mini-103MN, User Manual

Page: 58 / 70

58
check the cable connection. If the pins are damaged, contact your dealer for a replacement
connector.
Windows 95/98/Me/NT/2000/XP Troubleshooting
Multi-Segment LAN Environment Installation (through the Network Print Port)
If your print server and Windows 95/98/Me/NT/2000/XP/2003/Vista/7 are located on two
different segments, and your Windows NT server is used as the router/gateway you will need
to implement the following procedures in order for your print server to function properly:

Add the RIP for NWLink IPX/SPX compatible transport. See RIP for NWLink IPX/SPX
compatible transport Installation Procedure later in this section.

Add the frame type 802.2 for both Ethernet adapters. See Multi-Segment Frame Type
802.2 Installation later in this section.
RIP for NWLink IPX/SPX compatible transport Installation Procedure
1. From your Windows NT server that is used as a router, select Start from the bottom
left hand corner of the screen.
2. Select
Settings .
3. Select
Control Panel .
4. Double-click
the Network icon.
5. Select
Services .
6. Select
Add .
7.
In the Select Network Service box, select the RIP for NWLink IPX/SPX compatible
transport . Click OK .
8.
Follows the directions on the screen.
9. Done.
Multi-Segment Frame Type 802.2 Installation
1. From your Windows NT server that is used as a router, select Start from the bottom
left hand corner of the screen.
2. Point
to Settings , and select Control Panel .
3. Double-click
the Network icon.
4. Select
Protocols .Select the NWLink IPX/SPX Compatible Transport .