-23
5.
lnstall End plate (43) into Casing (42).
Assembling direction differs depending on the models. See Fig. 8.
NOTE : Be careful grease does not adhere to the lining of Brake cone (51).
EHW-60
EHW-120
EHW-60R
EHW-120R
End plate (43)
Casing (42)
Fig. 8
-8) lnstall Hook (56) and Washer (60) in Casing (1). lnstall Casing (42) on Casing (1).
Tighten Cap screws (61), (62) sequentially by 1/6 turns, then tighten Cap screw (63).
-9) Air motor unit
lnstall Cylinder (64), Key (65), Rotor (66), and Vanes (67) in this order.
Rotate Cylinder (64) when installing Vanes (67).
Lubricate Vanes (67) a little. (Use the same lubricant used for the lubricator.)
See Chapter
8,
Section
8.
1 "(3) Recommended Lubricants".
-10) Valve body part (70)
Check there are no flaws on the outer surface of Valve cone (72) and the inner surface
of Valve body (70) (the sliding surface where Valve cone (72) contacts].
lnstall 0-ring (73) to Plug (71), and install them in Valve body (70).
Apply grease to the grooves of Valve cone (72) and install Mini Y-packings [for EHW-60
and EHW-120: (110), for EHW-60R and EHW-120R: (105)].
After installing Mini Y-packings, apply grease a little to Mini Y-packings. (See Fig.
9.)
Mini Y-packing
For EHW-60 and EHW-120:(110)
For EHW-60R and EHW-120R:(105)
Pay attention to the
mounting direction.
Valve corn (72)
Apply grease to the outer surfaces.
Fig. 9