17. Professional Monitoring Service Function.
This alarm system has a function which supports the use of professional monitoring service. To activate this function
(with your system in
programming status),
enter the number sequence below into the keypad. In place of the {0000
to 9999}, enter the four digit (CONTACT ID) number. To deactivate this function, enter the coded sequence into the
keypad and in place of the {0000 to 9999}, enter “0000”.
Notice: this system will support professional monitoring service which use the “ CONTACT ID” , the local number of the professional monitoring
service must be enter as the fifth or sixth number only in the
“ Stored Phone Number”
,
5
=>
2
=>
*
=>
{0000
to
9999}
=>
#
Professional
CONTACT ID code,
must be 4 numbers
18. Exit Programming Status.
When you have completed programming the system’s functions, push the button
Exit
on the keypad; after 30 second
system will automatically exit
“programming status”
18. Resetting Your System Functions.
Reset your system to the factory default setting. The factory default password is “
1234
”
#
=>
turn off power
=>
turn on power
STEP 3
Operating the System
Arming Function: all sensors active.
Home Arm Function: all sensors active except motion detectors.
1.
Keypad/Controller Operation.
To
ARM
the alarm system: press the
away
button and hold for 3 seconds.
To
HOME ARM
the alarm system: After system is in the
arm
position, press the
home
button and hold for
3 seconds.
To
DISARM
the alarm system: press
pa disarm
For
emergency
: press the
panic
button.
