Chapter 5 Management Page 44
5.5 Restore Factory Default Settings
The WNAP-6300 provides two ways to restore the factory default settings:
Restore factory default settings via Web
From “
Configuration File
”, clicking “
Reset
” will eliminate all current settings and reboot your
device, then default settings are applied.
Figure 20 Restore Settings
Restore factory default settings via Reset Button
If software in WNAP-6300 is unexpectedly crashed and no longer reset the unit via Web, you may
do hardware reset via the reset button. Press and hold the button for at least 5 seconds and then
release it until the PWR LED gives a blink.
5.6 Reboot
You can reboot your WNAP-6300 from “
Configuration File
” in “
Management
” as below:
Click “
Reboot
” and hit “
Yes
” upon the appeared prompt to start reboot process. This takes a few
minutes.
