802.11 Access Point. All communication is done via the Access
Point or Router.
Ad-Hoc
– Select this mode if you want to connect to another
an
X Power
you want to lower the transmit power of the card for saving the
d Hoc Wireless Mode
hen the card is set in Ad Hoc (Peer to Peer Mode), you can
k.
02.11 B/G mix
– If you have a mix of 802.11b and 802.11g
g the
02.11 G only
– This card can be compatible with both 802.11g
reamble
he preamble defines the length of the CRC block for
only active
here are two modes including Auto and Long Preamble. If
TS Threshold
inimum packet size required for an RTS (Request To Send). For
ragment Threshold
he value defines the maximum size of packets; any packet size
bytes.
wireless stations in the Wireless LAN network without through
Access Point or Router.
T
If
power of the system, you can select the lower percentages from
the list. The lower power will cause the lower signal strength and
the coverage range.
A
W
designate the wireless connection mode for the Ad Hoc networ
802.11 B only
– This card can be compatible with both 802.11g
and 802.11b wireless stations. If there are only 802.11b wireless
stations in the network, you can set the card to this mode.
8
wireless stations in your network, it is recommended to settin
card to this mode. This mode is also the default setting.
8
and 802.11b wireless stations. If there are only 802.11g wireless
stations in the network, you can set the card to this mode.
P
T
communication among wireless devices. This option is
in the Ad Hoc network.
T
“Auto“ mode is selected, the card will auto switch the preamble
mode depending on the wireless devices the card is connecting
to.
R
M
packets smaller than this threshold, an RTS is not sent and the
packet is transmitted directly to the wireless network. Select a
setting within a range of 0 to 2347 bytes. Minor change is
recommended.
F
T
larger than the value will be fragmented. If you have decreased
this value and experience high packet error rates, you can
increase it again, but it will likely decrease overall network
performance. Select a setting within a range of 256 to 2346
10
