Installation
7
•
If desired, connect the DMZ port to a standard port on a Hub. PCs connected to
this hub will also gain Internet access, but will NOT be able to access the rest of
the LAN.
3. Connect WAN Cable
Connect the DSL or Cable modem to the WAN port on VRT-401. Use the cable
supplied with your DSL/Cable modem. If no cable was supplied, use a standard
cable.
4. Power Up
•
Power on the Cable or DSL modem.
•
Connect the supplied power adapter to VRT-401 and power up.
Use only the power adapter provided. Using a different one may cause hardware
damage
5. Check the LEDs
•
The
Power
LED should be ON.
•
The
Status
LED should flash, then turn Off. If it stays on, there is a hardware error.
•
For each LAN (PC) connection, the LAN
Link/Act
LED should be ON (provided the
PC is also ON.)
•
The
WAN
LED should be ON.
For more information, refer to Front-mounted LEDs in Chapter 1.
Using the DMZ Port
Please note the following points regarding the DMZ port.
•
The DMZ port is a normal port, not an "uplink" port.
•
PCs connected to the DMZ port are on the same LAN segment as PCs connected
to the Hub ports. They must use the same IP address range.
•
PCs connected to the DMZ port are NOT visible to PCs on the hub (LAN) ports. So
you cannot use Microsoft networking or other networking protocols to connect to
PCs on the DMZ.
•
PCs connected to the DMZ port still share the WAN port IP address for Internet
access.
Advantages of the DMZ Port
If running any Servers on your LAN, you should connect them to the DMZ port, for the
following reasons:
•
Traffic passing between the DMZ and LAN passes through the firewall. The fire-
wall will protect your LAN if your Server is compromised and used to launch an
attack on your LAN.
•
When using the
Virtual Servers
feature, (see
Virtual Servers
in Chapter 6) a fire-
wall rule to allow incoming traffic from the Internet (WAN) to the DMZ is
automatically created. If the Server is connected to the LAN (hub) ports, you must
add the firewall rule manually.