13
Step 4:
VF-102-R (Receiver)
: Connect coaxial cable from
monitor / DVR to Video BNC port of the VF-102-R.
Step 5:
Connect the 5VDC power adapter to the VF-102-T / VF-
102-R and verify that the Power LED lights up.
Step 6:
Turn on the power of the analog camera / monitor; the
VIDEO LED (Green) should light when all cables are
attached.
Speed Dome
DVR / Monitor
Control Keyboard
Fiber-optic
Audio Line / Video Line
A/V
Serial Line (RS-485)
|O|O|
A/V
|O|O|
A/V
|O|O|
A/V
A/V
Up to 20km
Coax
Coax
VF-102-T
Transmitter
VF-102-R
Receiver
Figure 3-1
VF-102-T / VF-102-R stand alone installation
3.3 Chassis Installation and Rack Mounting
To install the Video over fiber Converter in a
10-inch
or
19-inch
Converter Chassis with standard rack, follow the
instructions described below.
Step 1:
Place your Converter Chassis on a hard flat surface,
with the front panel positioned towards your front side.
Step 2:
Carefully slide in the VF module until it is fully and
firmly fitted into the slot of the converter chassis.
Figure 3-2
Insert a video over fiber converter into an available slot