12
3 INSTALL THE CONVERTER
This section describes how to install your VF-102 Media
Converter and make connections to the converter. Please read
the following topics and perform the procedures in the order
being presented. The hardware installation of PLANET VF-
102 Media Converter do not need software configuration. To
install your VF-102 on a desktop or shelf, simply complete the
following steps.
3.1 Limitation
The Converter does not require any software configuration.
Users can immediately use any feature of this product simply
by attached the cables and plug power on. There is some key
limitation on the video over fiber converter. Please check the
following items:
The device is used for
Point-to-Point
connection only (trans-
mitter to receiver) and allows video and data work on the
same optical fiber patch cord.
The BNC connector and supports 75 ohm cable. The distance
will change by the quality of coaxial cables.
3.2 Stand-alone Installation
To install a VF-102-T / VF-102-R stand-alone, on a desktop or
shelf, simply complete the following steps:
Step 1:
Turn off the power of the analog camera / monitor to
which the VF-102-T / VF-102-R will be attached.
Step 2:
VF-102-T (Transmitter)
: Connect coaxial cable from
analog camera to Video BNC port of the VF-102-T.
Step 3:
Attach FC single mode fiber cable from the VF-102-T to
VF-102-R in the remote side.
l
l