18
1. Make sure both sides of the SFP+ transceiver are with the same
media type; for example, 10GBASE-SR to 10GBASE-SR, 10GBASE-LR
to 10GBASE-LR.
2. Check whether the fiber-optic cable type matches the SFP+ trans
-
ceiver model.
To connect to 10GBASE-SR SFP+ transceiver, use the multi-mode
fiber cable with one side being the male duplex LC connector type.
To connect to 10GBASE-LR SFP+ transceiver, use the single-mode
fiber cable with one side being the male duplex LC connector type.
Connecting the fiber cable
1. Attach the duplex LC connector on the network cable to the SFP+
transceiver.
2. Connect the other end of the cable to a device, switches with SFP+
installed, fiber NIC on a workstation or a Media Converter.
Removing the Transceiver Module
1. Make sure there is no network activity by consulting or checking with
the network administrator. Or through the management interface of
the switch/converter (if available) to disable the port in advance.
2. Remove the Fiber Optic Cable gently.
3. Turn the lever of the MTB module to a horizontal position.
4. Pull out the module gently through the lever.
MTB
Series
Transceiver
1
2
Figure 3-2:
Pulling Out from the Transceiver
