19
Note
The wire gauge for the terminal block should be in the
range between 12 and 24 AWG.
2.1.5 Wiring the Fault Alarm Contact
The fault alarm contacts are in the middle of the terminal block
connector as the picture shows below. Inserting the wires, the
Industrial Fast Ethernet Switch will detect the fault status of the power
failure, or port link failure (available for managed model) and then
forms an open circuit. The following illustration shows an application
example for wiring the fault alarm contacts.
1 2 3 4 5 6
Insert the wires into the fault alarm contacts
Note
1. The wire gauge for the terminal block should be in
the range between 12 and 24 AWG.
2. Alarm relay circuit accepts up to 30V, max. 3A
currents.
Summary of Contents for ISW-511 Series
Page 23: ......
