Hardware Installation
The PLANET IDL-4802 is a 1.5U high box-type IP DSLAM with rack-mountable
enclosure. It can be installed in a standard 19-inch rack by using the mounting
brackets provided. Mount the shelf on the rack using the large screws provided.
STANDARD
FRONT MOUNT
FRONT
MOUNTING
BRACKET
MOUNTING
BRACKET
The procedures to connect and wire the system are as follows,
1. Power and Ground Connections
Power Connections
With IDL-4802, connect the AC power cord to the AC supply socket on the rear
panel as below figure, and plug the cord into the external power source. The
voltage must be 100 to 240V AC.
With IDL-4802-48, the DC power interface is a 4-pin terminal block with polarity
signs on the front panel as below figure.
It can be powered from two –48V DC power supply. The DC power connector is a
4P terminal block; 2P is for accommodating one DC power input and other 2P is
for accommodating another DC power input. The DC power should be connected to
a well-fused power supply.
After completing chassis installation, please apply power to the fused power
distribution panel feeding the chassis. When using a DC voltmeter, please check for
proper voltage: -60V ~ -36V DC, and make sure that the polarity is correct.
