5 Mega-pixel Outdoor IR PoE IP Camera
User’s Manual of ICA-3550V
Motion Detection
IP CAMERA allows 3-area motion detection. When motion is triggered, it can
send the video to some specific mail addresses, transmit the video to remote ftp
server and SAMBA, and trigger the relay. To set up the motion area, click “Area
Setting” and use mouse to drag and draw the area. The same operation is done
for areas 2 and 3.
Interval
For example, if you select "10 sec" here, once the motion is detected and action
is triggered, it cannot be triggered again within 10 seconds.
Based on the
schedule
When the option box is ticked, only during the selected schedule time the motion
detection is enabled. That is, for example, the 11th hour of Monday has not been
colored in the schedule table, then no action will be triggered even the camera
detects motion during 11:00~12:00 on Monday.
Tampering
Detection
If user enables this function and when anything covers LENS of camera, it will
send the video to some specific mail addresses, transmit the video to remote ftp
server and SAMBA, and trigger the relay.
Record File
Setting
IP CAMERA allows 3 different types of recording files to change its record size.
When motion/alarm is triggered, there are 3 different types of recording modes,
and they are:
(1) AVI File (with Record File Setting )
(2)
.
Multi-JPEG (with Record File Setting), only with JPEG compression format.
(3) Single JPEG (Single File with Interval Setting)
Record Time
Setting
Pre Alarm and Post Alarm setups for video start and end time when motion
detects I/O, or other devices got triggered.
Pre/Post Alarm record time is based on record time setting and IP cam
built-in RAM memory. Limited by IP cam built-in Ram memory and
when information is too much or video quality is set too high, it will
cause recording frame to drop or decrease post alarm recording time.
Network
Disconnected
To avoid video loss, the camera will start to save the video to local SD card
when it detects no network connection. The video recording will continuously be
saved into SD card and divided into every 10 minutes a file until the network is
reconnected successfully. The oldest file will be deleted if the capacity of SD card
is full.
Network IP Check
Key in the target IP address and interval. The camera checks once in a while
according to the setting interval time if it can link to the target IP address. If
connection fails, the camera starts to save the video to SD card
5.4.2 Schedule
Schedule
After completing the schedule setup, the camera data will be
recorded according to the scheduled setup.
Snapshot
After enabling the snapshot function, user can select the storage
position of snapshot file, the interval time of snapshot and the
reserved file name of snapshot.
64
